Google Outbound Services Configuration Guide Bedienungsanleitung PDF herunterladen (Seite 118)

Sendmail 127

Increase Server Timeouts

Changing server timeouts should not be necessary. In Sendmail, server timeout is

set in the value

Timeout.datafinal

. By default it is set to 1 hour. If

Timeout.datafinal

has been changed to a lower value, raise the value to 1 hour.

Set Up Smarthost

Set the smarthost in your sendmail.mc file.

WARNING: Do not change this value until you have set up the appropriate

RELAY_DOMAIN setting and registered your IP in the Administration Console. If

your IP is not registered in the Administration Console, Outbound Services will not

deliver your mail.

Configure a smarthost to route traffic to Outbound Services

1. Add the following line to the

/etc/mail/sendmail.mc

file:

define('SMART_HOST',outbounds[your system number].obsmtp.com)

where

[your system number]

is your system number. To find what system to

use, see “Identify Your System” on page 13.

2. Stop and restart the sendmail server process.

Test Outbound Mail

Once you have set up your smarthost, test that your configuration is correct and

mail is flowing normally.

Test the configuration.

1. Send a message from a mail client inside your network to an outside address.

You should see a line in the header email which indicates being received and

delivered by

exprodNobM.obsmtp.com

, where N and M are numbers.

2. Test inbound mail to confirm normal functionality. Send a message from an

outside email address to an address on your service.

3. In the Administration Console, select your email config organization and click

the Outbound Servers tab. After a minute of successful mail flow, traffic

should display on the graph.

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 127 128

Keine Kommentare

Google Outbound Services Configuration Guide Bedienungsanleitung Seite 118